At the bottom of the Simulation view, a single instruction table row is displayed. This row contains the instruction currently being executed.
The MPM can be modified by this line. This is not recommended, however, because changes done here are not reflected in the MPM file, and will be undone if the MPM file is hot-replaced (see below), even if the changed row didn't change in the hot replace. Also, as for a hot replace, these changes doesn't affect the currently active microinstruction.
At the bottom of the Simulation view, a single instruction table row is displayed. This row contains the instruction currently being executed.
The MPM can be modified by this line. This is not recommended, however, because changes done here are not reflected in the MPM file, and will be undone if the MPM file is hot-replaced (see below), even if the changed row didn't change in the hot replace. Also, as for a hot replace, these changes doesn't affect the currently active microinstruction.