Update getting_started.md

[Mograsim.git] / docs / getting_started.md

diff --git a/docs/getting_started.md b/docs/getting_started.md
index 9285f4f..aa4df89 100644 (file)
--- a/docs/getting_started.md
+++ b/docs/getting_started.md
@@ -7,12 +7,18 @@
 
 ## Install Mograsim
 
+### Via the Eclipse Marketplace
+1. Start Eclipse.
+2. Go to "Help" -> "Eclipse Marketplace...".
+3. Search for "Mograsim"
+4. Click on "Install" and follow the instructions.
+
+### Manually via an updatesite
 1. Start Eclipse.
 2. Go to "Help" -> "Install New Software...".
 3. Add the Mograsim update site:
        1. Click on "Add...".
-       2. Next to "Location:", enter the update site address.  
-Note: Currently, there is no online update site for Mograsim. You have to build Mograsim yourself as described in [Building Mograsim](building_mograsim.md).
+       2. Next to "Location:", enter the update site address. Currently, this is https://mograsim.net/updatesite/. This address could, however, change in the future.
        3. Click on "Add".
 1. Tick "Mograsim".
 2. Click on "Next >" two times, read and accept the license, and click on "Finish".
@@ -37,7 +43,7 @@ Alternatively, you can create a general Project and add the Mograsim nature to t
 2. Go to the "Project Natures" page, click on "Add...". If a confirmation dialog pops up, confirm.
 3. Select "Mograsim Project Nature"; click on "OK".
 4. Click on "Apply and Close" and re-open the properties dialog.
-5. Go to the new "Mograsim" page, select "Am2900Simple", click on "Apply and Close".
+5. Go to the new "Mograsim" page, select "Am2900Teaching", click on "Apply and Close".
 
 ## Write a MPM file (containing the microprogram)
 
@@ -134,4 +140,4 @@ Slowly increase the simulation speed until the wires in the Simulation view star
 - If nothing Mograsim-related seems to be installed after installing Mograsim, make sure Eclipse uses Java 11 or later.
 1. Go to "Help" -> "About Eclipse IDE", click on "Installation Details", go to the tab "Configuration".
 2. Search the line starting with "java.version=". (This line is in the "System properties" block, which usually occupies the first 200 lines.)
-3. If this line specifies a version less than 11, configure your Eclipse installation to use a Java 11 JRE (or later). See https://wiki.eclipse.org/FAQ_How_do_I_run_Eclipse%3F#Find_the_JVM.
\ No newline at end of file
+3. If this line specifies a version less than 11, configure your Eclipse installation to use a Java 11 JRE (or later). See https://wiki.eclipse.org/FAQ_How_do_I_run_Eclipse%3F#Find_the_JVM.